Fit shower screen seal

€40
Task Assigned

Description

I am replacing the seal on the bottom of the shower screen, which is on the side of the bath. I need the new seal cut to size, it's too long and then shaped in where it meets the glass panel so that it doesn't allow water out when the shower is on - over bath shower.

Task Location: Linnetfields Ct, Castaheany, Clonee, Co. Dublin
Due date: Flexible
Date Posted: 23 Dec 2024
Posted by:
Noreen B
Noreen B.
Assigned to:
James H
James H.

Comments & Offers

Task Assigned: Comments are now closed
James H. 20 days ago

Yes that's no problem Noreen. Whenever it suits you can accept the offer, you'll have to pay a small booking deposit then we can exchange details etc. Thank you.

Noreen B. 20 days ago

@James H. Hi James, that would be good if you could do it after 29th, maybe the week of 30th?

James H. Made an offer 21 days ago
Noreen B. 22 days ago

@Donagh M. It will only be a 5 minute job, €120 is too much but thanks for getting in touch

Noreen B. 22 days ago

@Donagh M. Hi, there is a little gap between where the left side of the seal meets the chrome bar of the shower screen, so the top part of the seal which is hard plastic needs to be cut in and needs to be a little shorter than the flappy plastic part of the seal below it. Where the top part of the seal hits the bar, that part of the bar juts out a little to the right, but the bar juts in again underneath that where the flappy bottom part of the seal touches it. Hard to explain.

Donagh M. 22 days ago

When you say "shaped in" do you mean bent in towards bath so water runs into bath?